Setting insertion axis

From exocad documentation

Jump to: navigation, search
WarningThis page documents exocad's software releases from 2015 on. See documentation for older versions


Contents

When this Dialog is Displayed

You will not always get prompted for the insertion axis. The software can accurately autodetect the proper insertion axis in the vast majority of cases. You will be asked to check the detected insertion direction in the following cases:

  • When constructing bridges for 3-axis or 4-axis milling
    • For 3-axis milling, it is required - due to production constraints - that all teeth within a bridge have the same insertion axis. The detected common insertion axis is shown to the user, who can then optimize this sometimes difficult decision.
  • When the software has doubts about the insertion axis it auto-detected
    • Even for single crowns/copings, or for bridge elements in 5-axis milling, you are sometimes prompted to verify/correct the detected insertion axis. This is usually the case when dealing with dubious preparations (e.g. when the margin line lies within an undercut area).
  • For all inlay constructions

Insertion Direction - NEW white - NEW - PNG - PIC.png

Checking/Editing the Insertion Axis

The software will present you its auto-detected insertion axis by adjusting the viewpoint so that you look onto the preparation(s) from the insertion direction. Additionally, undercuts will be marked with a color scale.

Setting a New Insertion Axis

To change the insertion axis, rotate the view so that you look onto the preparation(s) from your desired insertion direction. Then, click Set current view as insertion axis [4] to set this as the new insertion axis. The Undercut visualisation [3] will be updated.

Applying a Common Insertion Axis for Several Constructions

In 5-axis or laser melting mode, the software allows different insertion directions for parts within a bridge. To enforce the same insertion axis for several parts, click the respective tooth within the tooth selection control [1]. For example, in the above screenshot – which prompts you for the insertion axis of tooth 11 – click the tooth symbol 12 to ensure that teeth 11 and 12 share the same insertion axis. Click 12 again to undo.

Check Unique insertion direction [2] for bridges to enforce a common insertion axis for all parts of the currently edited bridge (default in 3-axis mode).

WarningIn 3-axis mode, uncheck this box only if you really know what you're doing.

When you are finished defining the insertion axis, click 'Next' in the Wizard window to proceed to the next step.

TipNext: Designing the inside of the crown
Personal tools
GermanFrenchItalianSpanishChinese (simplified)